You can boot into Windows and try running it anyways just for confirmation. If the LiteOn LTN 526 CD-ROM drive cannot be detected in the working computer then I highly doubt that the Windows firmware update application that you have downloaded will work. ![]() Plug the AC power cable back into the power supply unit of the good computer and turn it on.Įnter the BIOS Setup Utility and confirm that the LiteOn LTN 526 CD-ROM drive has been detected or change the BIOS settings to auto-detect it. Plug in the 4-pin Molex power connector from the power supply unit to the CD-ROM drive. Plug the LiteOn LTN 526 CD-ROM drive along with its ribbon cable into the ATA 100/66/33 IDE connector on the motherboard of the good computer. The following steps assume that your good computer has an ATA 100/66/33 IDE connector on the motherboard.ĭisconnect the AC power cord from the power supply of both computers before disconnecting or reconnecting any devices.ĭisconnect the LiteOn LTN 526 CD-ROM drive from the problem computer along with the ribbon cable.ĭisconnect the CD-ROM drive from the good computer. Just download the firmware update file and extract the 526YH0X.EXE Windows application file to a hard disk drive on the good computer. Try it in another computer to make sure the drive works. If you don't see the CD-ROM drive after this then there is something wrong with the CD-ROM drive. If the CD-ROM drive gets detected you will see the CD-ROM drives model designation like the above example. If you see this option press Enter to force an auto detection of your CD-ROM drive. If a sub-menu pops up you may see IDE HDD Auto-Detect. If the IDE Channel 0 Master shows then select this entry press Enter and change it to. IDE Channel 0 Master <- This is a Samsung IDE CD/DVD drive IDE Channel 0 Master : TSSTcorp CDDVDW SH-S202J SB01 Standard CMOS Features ![]() Memory Clock is : 800 MHz Tcl:5 Trcd:5 Trp:5 Tras:15 (2T Timing) 128 bit On the first POST (Power On Self Test) screen you should see something like the following example: If you set it to RAID or AHCI you will need to Press F6 during the Windows XP installation and provide Intel ICH6 RAID or AHCI drivers on floppy diskette before the SATA hard disk drive will be recognized by the Windows XP installation routine. In this mode you don't need to Press F6 during Windows XP installation to provide a device driver for the Intel SATA controller. The default IDE setting makes the SATA controller emulate an IDE controller. ![]() The available setting values are: IDE, RAID, AHCI. In the section "*** On-Chip Serial ATA Setting ***" Main Menu of CMOS Setup Utility -> Integrated Peripherals Main Menu of CMOS Setup Utility -> Advanced BIOS Features Your LiteOn LTN 526 CD-ROM drive should be connected to the black connector on the end of the IDE ribbon cable.Īssuming the only hard disk drive you have connected is the Western Digital Caviar WD800BD change the boot device sequence from its default (Floppy/Hard Disk/CDROM) to: The device at the end of the IDE cable (black connector) is the Master device and the device in the middle (gray connector) is the Slave device. The blue connector on the IDE ribbon cable is connected to the motherboard's ATA 100/66/33 IDE connector. If you are using CS then the position of the device on the IDE cable determines whether the device will be a Master or a Slave assuming you're using an 80-conductor IDE ribbon cable that handles two IDE devices. Since the LiteOn LTN 526 CD-ROM drive is the only device on the IDE (PATA) ribbon cable it should be jumpered as a Master or CS (Cable Select).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |